Ideal for heating up to 2,100 ft², the Escape 1800 is the ultimate versatile wood insert! With only 1.54 g/h of particulate emissions, this non-catalytic appliance gives off up to 75,000 BTU/h. The Escape 1800 is the perfect choice to update your masonry fireplace and make it efficient!
Included: blower, ceramic glass, ash lip, air damper
Burn time up to 8 hours
Up to 20'' logs
2.4 ft³ firebox
Robust 5/16'' steel
EPA certified
Proudly made in Canada
Limited lifetime warranty
Options: faceplate (regular or large) with brushed nickel trim or cuttable faceplate, firescreen, fresh air intake
(1)This appliance is officially tested and certified by an independent agency.
(2)Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time and maximum heat output.
()Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.
(3)The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³ and reloading intervals ranging from 60 to 120 minutes. Other performances are based on a fuel load prescribed by the standard without any reloading between start and finish. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.
(4)As measured per CSA B415.1-10 stack loss method.
(5)Higher Heating Value of the fuel.
(6)Lower Heating Value of the fuel.
(7)Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.
(8)Optimum overall efficiency at a specific burn rate (LHV).
(9)The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the wood logs into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.
(10)Carbon monoxyde.
GENERAL FEATURES:
Combustion technology
Non-catalytic
High-efficiency certified appliance
Yes, EPA 2020 approved
Maximum log length
20"
Log positioning
Loading over width
Chimney diameter
6"
Flue outlet diameter
6"
Type of chimney
Liner - ULC-S635, CAN/ULC-S640, UL1777
Minimum chimney height (feet)
12'
Baffle type
High quality vermiculite
Approved for a mobile home installation
No
Shipping Weight
392 lb (178 kg)
Door type
Single, glass with cast iron frame
Glass type
Ceramic glass
Glass surface – dimensions (Width X Height)
16" X 9 1/4"
Glass air-wash system
Yes
Premium quality blower included (CFM)
144
Overall dimension (Height)
23 1/8"
Overall dimension (Width)
28 3/8"
Overall dimension (Depth)
26 3/8"
Door opening – dimension (Height)
9"
Door opening - dimension (Width)
17 1/2"
Firebox – dimension (Height)
11 7/8"
Firebox – dimension (Width)
21"
Firebox – dimension (Depth)
16 1/2"
Firebox lined with refractory bricks for better heat distribution
Yes
Stainless-steel secondary-air system improving gas combustion
Yes
Adjustable threaded legs
Yes
Steel thickness – body
3/16"
Steel thickness – top
5/16"
Fireplace opening – minimum (Height)
23 3/8"
Fireplace opening – minimum (Width)
28 7/8"
Fireplace opening – minimum (Depth)
15 3/4"
USA standard (emissions)
EPA Method 28
Canadian Standard (emissions)
CSA B415.1-10
USA standard (safety)
UL 1482, UL 737
Canadian standard (safety)
ULC S628
Tested and listed as per applicable standards
By an accredited laboratory (CAN/USA)
Warranty
Limited lifetime
Minimum clearances to combustibles* (Data expressed in inches. 1 inch = 25.4 mm)
Canada
United-States
Clearance – top (measured from the platform on which the appliance is installed)**
84"
84"
Clearance – combustible side mantle to unit
9"
9"
Clearance – combustible top mantle to unit
27"
27"
Clearance – combustible side wall to unit
16"
16"
Clearance – minimum floor protection in front of the appliance
18"
16"
Clearance – from the top of the insert to the shelf
27"
27"
* The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner's manual, catalogues, flyers, magazines and/or web sites).
** Some appliances have been tested with a low ceiling. Before setting up your unit, refer to the installation manual.
Freight Shipments ship via Freight Curbside delivery. In other words, the shipping carrier will drop off your item on your property not inside your home. The shipping courier will call ahead of time and schedule a drop off date with you. In some cases, white glove delivery is available. Call Us for additional details.
Mont Alpi Fridge Module Cover - COVCAB-R/L Michael
Mont Alpi cover
I am completely satisfied with PrimeFair service. Not so much with the product itself though - but that has nothing to do with the seller, rather it’s a manufacturer decision to have cover without side piece. So, basically you are getting just one piece of cover that goes front-top-back only and doesn’t cover side of a cabinet.